ps2ps, eps2eps - Ghostscript PostScript "distiller"
ps2ps [ options ] input.ps output.ps
eps2eps [ options ] input.eps output.eps
ps2ps uses gs(1) to convert PostScript(tm) file "input.ps" to simpler, normalized and (usually) faster PostScript in "output.ps". Normally the output is allowed to use PostScript Level 2 or Level 3 constructs, but the -dLanguageLevel=1 option restricts the output to Level 1.
eps2eps performs the equivalent optimization for Encapsulated PostScript (EPS) files.
Both accept any general Ghostscript command line options, and respectively options specific to the pswrite and epswrite devices.
Run "gs -h" to find the location of Ghostscript documentation on your system, from which you can get more details.
The pswrite device used by both ps2ps and eps2eps produces much lower level output than is desirable. Use with caution.
ps2pdf(1), ps2ascii(1), ps2epsi(1)
This document was last revised for Ghostscript version 8.15.
artofcode LLC and Artifex Software are the primary maintainers of Ghostscript. Please send bug reports to <[email protected]>.
See attributes(5) for descriptions of the following attributes:
ATTRIBUTE TYPE ATTRIBUTE VALUE Availability SUNWgscr Interface Stability Volatile
Source for ESP gs is available on http://opensolaris.org.
|8.15||PS2PS (1)||22 September 2004|